Bilge Water Separation Equipment

Bilge Water Separation Equipment

1. Bilge Water Separation Equipment Application

This bilge water separating equipment can be used to treat oily bilge water in order to make it reach the requirements of IMO.MEPC.107 (49) resolution, which is also called 15ppm bilge separator.It contains type approved 15ppm bilge water separator ,15ppm bilge alarm andAutomatic shut down device.
2. Bilge Water Separation Equipment Installation

(1) base of the device

All the components of the device are installed on the equipment base welded by channel steel. A ship base which matches the size of the bottom of the equipment base should be fixed in the machine cabin. The ship base should be welded with the ship structure. The ship base is connected to the bottom of the base of device by bolts and channel special square bevel gaskets GB/T853 suggested. See attached Figure 2, the size of the device base and the position of connecting bolt holes

(2) connection of electric box

Power source 380V/440V, 3Ф, 50HZ/60HZ is connected into electric control box; Bilge level probe, refer to electric draw, when the product leaves from the factory, the external contact points JYB3 ＃15, ＃5 or ＃6 of the liquid level relay which is used to detect the bilge water level are short connected. If bilge level probe needed to be linked, the short connected copper wire should be removed.
3. Warning of Bilge Water Separation Equipment

The operator should skill a basic technology and be familiar with the instruction. Also he should master the operation control and know clearly the maintenance regulations.

4. Bilge Water Separation Equipment General Drawing

5. Certificates of Bilge Water Separation Equipment: CCS, EC, BV, DNV.GL , KR, LR, ABS, RINA approvable.