Hydraulic Steel Shearing Machine
1. Hydraulic Steel Shearing Machine Preface
At a blistering 30 strokes a minute for 14 gauge mild steel the hydraulic steel shearing machine will save you time and money on your next metal shearing project. This machine uses 60" blades that can cut down to 14 gauge mild steel or 18 gauge stainless steel easily.
This machine is made of fully integrated and welded steel plate allowing enough rigidity to shear at full capacity all day long. Powered by a 3hp 220 volt three phase motor, the industrial hydraulics pull the top blade smoothly through the material being cut increasing blade life. This metal shears top and bottom shearing blades have multiple cutting edges that extend blade life. It also has a hold down carriage with 9 fingers hold the sheet metal firmly against the in feed table eliminating any lifting of material as it is cut, again this improves blade life.
This hydraulic steel shearing machine has a manual back gauge as well as front support arms to help the operator handle the sheet metal and provide for repeatable shearing. The operator control panel has a switch that allows the fabricator to jog the blade, do one cycle or cut, or go into an automatic mode that is initiated by the foot pedal control.
2. Specification of Hydraulic Steel Shearing Machine
The technical parameter is optional, we can accommodate your requirements, please don’t hesitate to contact us!
Back Gauge Length 24"
Shear Length 60"
Motor 3 hp
Thickness (SS) 14 ga. (18 ga.)
Strokes Per Minute 30
Front Gauge Length 24"
Blade Angle 1°
Power 220V / 3-phase
Shipping Weight 3,200 lbs.
Minimum Material Thickness 24ga
Shipping Dimensions 84" x 36" x 56"
3. Hydraulic Steel Shearing Machine Workshop
Related products for "Hydraulic Steel Shearing Machine"
