NEWS

Production Process of Welding Anchor

1. Cleaning, the plates used to make welding anchors should be cleaned of oil and dust on the surface before use;

2. Cutting, cut the plate according to the required size, the joints that need to be welded after cutting should be matched;

3. Deburring and straightening, in order to avoid affecting the welding effect, the burrs, protrusions and other parts of the plate after cutting should be removed, and the bent parts should be straightened;

4. Welding, the joint parts of each workpiece should be consistent during welding, and the stability of the joint parts of the workpiece should be ensured during the whole welding process to avoid welding deformation;

5. Cleaning and grinding the weld. After the welding is completed, the weld should be cleaned to remove the residual slag at the weld. After the cleaning is completed, the weld should be polished. During the grinding process, the state of the weld should be observed, and the missing welding part should be polished after welded again;

6. Painting, the next step after all parts of the welding anchor are finished is dipping paint. After the paint surface of each part is dry, it can be assembled and packaged.