0.5 m³ Water and Oil Separator

0.5 m³ Water and Oil Separator

Introduction

This device can be used to treat the oily bilge water in order to reach the requirements of IMO.MEPC.107 (49) resolution, which is also called 15ppm bilge separator.

YWC-0.50 type device is mainly constituted by the 1st stage coalesce, the 2nd stage filter, the 3rd stage membrane, electric control box, oil content meter, MONO pump, pneumatic valve, pressure controller, temperature controller and so on.

Drawing & Specifications

No.	Name	Material
1	primary separator	Assembly
2	the 2nd stage filter	Assembly
3	the 3rd stage membrane	Assembly
4	Manual three-way valve	Assembly
5	Base	Q235-B
6	Piston pump	Assembly
7	15ppm Bilge alarm device	Assembly
8	Electric transformation components	Assembly
9	Electric control box	Assembly
10	Pressure gauge	Assembly
11	electric-contact thermometer	Assembly
12	Nameplate	SS
13	Vacuum pressure gauge	Assembly
14	Nameplate	SS
15	Dash board	Q235-B
16	two stage water inlet pipes	20#
17	pipe of back to bottom	Assembly
18	Ball valve	Assembly
19	Counter flushing water pipe	Assembly
20	pheumatic valve	Assembly
21	Medical pump	Assembly
22	Flow meter	Assembly
23	Dischage pipe	Assembly
24	Electric heater	Assembly
25	Check valve	Assembly
26	Three-way valve	Assembly
27	Medical box	Plastic
28	Level 3 feed line	Assembly

Rated Capacity (m3/h)	Discharged Water Oil Content	Electric Heater Power (KW)	Electric Motor Power (KW)	Electrical System	Suction Head	Discharged Water Pressure	Outline Dimension (mm)(L×W×H)	Base	Dry Weight	Wet Weight	Applicable Vessel (KDWT)
0.5	≤15ppm	3	0.55	AC 380V/50Hz/3φ, AC 415V/50Hz/3φ, AC 440/60Hz/3φ, AC 480V/60HZ/3φ, etc.	≤6m (H2O)	5-10m (H2O)	1100 × 690 × 1460	6#	600	900	1-5

IACS Certificate Options: BV, CCS, NK, DNV, GL, IRS, ABS, LR, RMRS, RINA